mic 초음파 센서

매우 튼튼한 구조

M12원형 콘넥터에 M30 전부 메탈하우징으로 되어있다. 센서에 모든 운용요소 및 신호램프등이 포함되어 있지않고 기계적 강도가 높은 하우징과 플러그 콘넥터를갖추고 있어서 극한환경 조건에서 사용하기 적합합니다.센서는 30mm 측정영역부터 다섯분류의 측정영역에서 유용합니다.

M12 metal circular connector (left) and operation under rough conditions (right)

두가지 출력 레벨

모든 다섯 측정영역에서 유용합니다.

	1 pnp switching output
	1 analogue output 4–20 mA and 0–10 V

Sensors with switching output have three operating modes:

• Single switching point
• Two-way reflective barrier
• Window mode

Teach-in of a single switching point

• Place object to be detected (1) at the desired distance
• Apply +U_B to pin 5 for about 3 seconds
• Then apply +U_B to pin 5 again for about 1 seconds

Teach-in of a switching point

Teach-in of a two-way reflective barrier with a fixed reflector

• Apply +U_B to pin 5 for about 3 seconds
• Then apply +U_B to pin 5 again for about 10 seconds

Teach-in of a two-way reflective barrier

For configuration of a window

• Place object at the near edge of the window (1)
• Apply +U_B to pin 5 for about 3 seconds
• Then move the object to the far edge of the window (2)
• Then apply +U_B to pin 5 again for about 1 seconds

Teach-in of an analogue characteristic or a window with two switching points

NCC/NOC

증가/감소 아나로그 구간을 pin5를 통해  세트할수 있다. 

LinkControl

optionally permits the extensive parameterisation of mic sensors. The LCA-2 LinkControl adapter available as an accessory can be used to connect mic sensors to the PC.

Sensor connected to the PC via LCA-2 for programming

Synchronisation

permits the simultaneous use of multiple mic sensors in an application. To avoid mutual interference, the sensors can be synchronised with one another. To do this, all the sensors are electrically connected on pin 5.

Synchronisation using Pin 5

If more than 10 sensors must be synchronised, this can be carried out with the SyncBox1, available as an accessory.