Archive sensor
Trans-O-Prox II
Ultrasonic-Specific
echo propagation time measurement
5 cm
Electrical Data
24 V d.c., reverse polarity protection
± 10 %
≤ 50 mA (without sensors)
screw terminals, wire cross-section 1.5 mm2
outputs
switching output
pnp: Imax = 500 mA (UB-2V)
NOC/NCC adjustable, short-circuit-proof
pnp: Imax = 500 mA (UB-2V)
NOC/NCC adjustable, short-circuit-proof
switching output
pnp: Imax = 500 mA (UB-2V)
NOC/NCC adjustable, short-circuit-proof
pnp: Imax = 500 mA (UB-2V)
NOC/NCC adjustable, short-circuit-proof
transponder mode: 500 ms, echo mode: 240 ms
Inputs
com input
enable-input
control input
tachometer input
control
RS-232 interface
+UB at the enable input activates Trans-O-Prox III.
If the -UB is at the control input (mode) or the terminal is open, then Trans-O-Prox III operates in the echo mode. If the +UB is at the control input, Trans-O-Prox III operates in the transponder mode.
The Trans-O-Prox III can adjust the speed-dependent switching thresholds conditional upon a 0..20 mA signal at the tachometer input.
+UB at the enable input activates Trans-O-Prox III.
If the -UB is at the control input (mode) or the terminal is open, then Trans-O-Prox III operates in the echo mode. If the +UB is at the control input, Trans-O-Prox III operates in the transponder mode.
The Trans-O-Prox III can adjust the speed-dependent switching thresholds conditional upon a 0..20 mA signal at the tachometer input.
housing
Kunststoffgehäuse mit 28 Schraubklemmen, geeignet für Hutschinenmontage DIN EN 50022-35
polyurethane foam, epoxy resin with glass contents
IP 20
-20°C to +70°C non-condensing
-20°C to +70°C
200 g
Technical Features/Characteristics
3 push-buttons
at the evaluator
with terminal programme via serial interface
with terminal programme via serial interface
yes
no
2 x LED yellow: switch status, 2 x LED red: operating status
archive sensor
