ucs传感器坚固的金属外壳与工业标准的光电传感器相互兼容。
可以灵活的选择安装位置并使接线更加灵活。
 |
are available with 2 anti-valent pnp or npn switching outputs. |
传感器顶部的自学习按钮，使得对所需的检测点和工作模式的设置变得非常方便。
显示两个开关量输出的开关状态。
有三种工作模式：
将传感器放置在想要的检测距离处，使其被检测到。按下按钮大约3秒，再次按下按钮大约1秒，设置完毕。窗口模式和反射板模式也可以用同样简单的方法设置。.
can be set up with the help of a permanently mounted reflector by mounting the ucs sensor and the reflector, then pressing the button for approx. 3 seconds and then pressing it once more for approx. 10 seconds. Now, the two-way reflective barrier has been set.
by initially positioning the object to be detected on the sensor-close window limit (1), pressing the button for approx. 3 seconds, shifting the object to the sensor-distant window limit (2) and pressing the button once more for approx. 1 second. Ready.
can be synchronised with one another. To do this, all the sensors are electrically connected on pin 5 on the M12 circular connector.
If more than 10 sensors must be synchronised, this can be carried out with the SyncBox1, which is available as an accessory.
optionally permits the extensive parameterisation of ucs sensors. The LCA-2 LinkControl adapter, which is available as an accessory, can be used to connect ucs sensors to the PC.
