nero 초음파 센서

Sensorbild - Matrix

Overview

Ultrasonic proximity switch nero in M18 plastic sleeve with 4 detection ranges

센서 라인에 관하여 pdf로 다운 받으세요

하이라이트

  • Variant with 90° angled head
  • UL Listed to Canadian and US safety standards

Basics

  • 1 switching output, pnp or npn basis
  • Analogue output 4–20 mA or 0–10 V
  • 4 detection ranges with a measurement range of 20 mm to 1.3 m
  • microsonic Teach-in on pin 2
  • 0.2 mm resolution
  • 10–30 V operating voltage

특성

The nero ultrasonic sensors

are a compact series with M18 threaded sleeves and only 41 mm in housing length. In addition to the variants with an axial beam direction, there is also a housing variant with a 90° angled head and radial beam direction.

With four detection ranges from 20 mm to 1.3 m and three different output stages, this sensor family covers a wide range of applications.

For the nero sensor family

there are 2 output stages and 4 detection ranges available:

1 switching output with pnp or npn switching technology
1 analogue output 4–20 mA or 0–10 V

Sensors with switching output have three operating modes:

  • Single switching point
  • Two-way reflective barrier
  • Window mode

Teach-in of a single switching point

  • Place object to be detected (1) at the desired distance
  • Apply +UB to pin 2 for about 3 seconds
  • Then apply +UB to pin 2 again for about 1 seconds

Teach-in of a switching point

Teach-in of a two-way reflective barrier

with a fixed reflector

  • Apply +UB to pin 2 for about 3 seconds
  • Then apply +UB to pin 2 again for about 10 seconds

Teach-in of a two-way reflective barrier

For configuration of a window

  • Place object at the near edge of the window (1)
  • Apply +UB to pin 2 for about 3 seconds
  • Then move the object to the far edge of the window (2)
  • Then apply +UB to pin 2 again for about 1 seconds

Teach-in of an analogue characteristic or a window with two switching points

NCC/NOC

and rising/falling analogue characteristic curve can also be set via pin 2.

One green and one yellow LED

indicate the state of the output and support microsonic teach-in.

Top